AEGIS® Ring Installation with Conductive Epoxy

This video shows everything you need to install  AEGIS Shaft Grounding Rings with conductive epoxy.

How to install AEGIS Rings with Conductive Epoxy - Only 4 minutes long!

1.  List of tools and supplied needed
2.  Personal Protective Equipment
3.  Where to install - DE (all motors) and NDE (TEFC motors)
4.  Removing the paint from the motors end bracket
5.  Clean the motor's shaft to bare metal where the AEGIS Ring fibers touch.
6.  Apply AEGIS Colloidal Silver Shaft Coating (CS015) to the motor's shaft.
7.  Use only AEGIS Conductive Epoxy - (EP2400) - Tested and proven
8.  Mix even amounts of the EP2400 thoroughly - MIX WELL
9.  Apply the mixed epoxy to the metal back of the AEGIS Ring
10.  Install the AEGIS Ring to the motor's end bracket - metal to metal contact!
11.  Make sure the AEGIS ring is centered around the shaft - look for even gap all around the ring near the shaft.
12. Use Heat gun to cure the EP2400 conductive epoxy - approximately 5 minutes - cures in about 30 minutes!